PIC kit 3

The PICkit 3 programmer/debugger is a simple, low-cost in-circuit debugger that is controlled by a PC running MPLAB IDE (v8.20 or greater) software on a Windows? platform. The PICkit 3 programmer/debugger is an integral part of the development engineer's toolsuite. The application usage can vary from software development to hardware integration. The PICkit 3 programmer/debugger is a debugger system used for hardware and software development of Microchip PIC? microcontrollers (MCUs) and dsPIC? Digital Signal Controllers (DSCs) that are based on In-Circuit Serial Programming? ICSP?) and Enhanced In-Circuit Serial Programming 2-wire serial interfaces. In addition to debugger functions, the PICkit 3 programmer/debugger system also may be used as a development programmer. The PICkit 3 programmer/debugger is not intended to be used as a production programmer. The debugger system executes code like an actual device because it uses a device with built-in emulation circuitry, instead of a special debugger chip, for emulation. All available features of a given device are accessible interactively, and can be set and modified by the MPLAB IDE interface. The PICkit 3 debugger was developed for emulating embedded processors with debug facilities. The PICkit 3 features include: ? Full-speed USB support using Windows standard drivers ? Real-time execution ? Processors run at maximum speeds ? Built-in over-voltage/short circuit monitor ? Low voltage to 5V (1.8-5V range) ? Diagnostic LEDs (power, active, status) ? Read/write program and data memory of microcontroller ? Erase of all memory types (EEPROM, ID, configuration and program) with verification ? Peripheral freeze at breakpoint